What issues should be paid attention to when choosing a cooling fan for a mining machine?

As a cooling fan factory familiar with mining machines, we know that the temperature in the mining machine room is like a sauna room. The temperature is high, but if the mining machine has a very high temperature, it will cause problems with the mining machine, and the state of restarting will appear. , It will eventually affect the mining machine’s calculations. Over time, it will cause irreversible damage, which will greatly consume the life of the mining machine. Therefore, it is necessary to do a good job of heat dissipation for the mining machine. The most effective way is to dissipate heat. The fan is used to dissipate the heat of the mining machine and discharge it to the outside of the mining machine, so that the working temperature of the mining machine is in the normal range. Then, what problems should be paid attention to for the cooling fan of the mining machine? Due to its high temperature and long-term use, the mining machine must ensure that the following two points must not cause problems. First, the air volume for heat dissipation and the air pressure must be large enough, even if the noise is louder, the fundamental heat must be relieved , As we said above, the high temperature of the mining machine will cause problems. Second, the quality of the cooling fan must be stable, and the cooling fan cannot be caused to work in a high temperature and dusty environment for a long time. Once it does not turn, the temperature of the miner immediately rises. Cooling fan manufacturers have opened multiple sets of molds for the cooling fans of mining machines. The most representative one is the 12038 cooling fan. We have 4 sets of molds. Among them, the following two 12038 high-volume wind pressure cooling fans are used for mining machines. . These two models use more cooling fans for mining machines. The first is 11 blades, 4300 rpm, and the second is 7 blades, 6000 rpm, the voltage is about 12V/2.4A, the air volume and pressure are very large, and the 4-wire PWM Intelligent speed control function, when the temperature of the miner is high, the speed of the cooling fan will automatically increase, otherwise, the speed will be slower and quieter. It not only effectively prolongs the life span, but also improves the comfort. For details, please refer to the detailed introduction of these two products. Welcome to the heat dissipation classroom and news center of the cooling fan manufacturer again. The copyright belongs to the cooling fan manufacturer and only represents personal opinions. Please do not reprint the whole article. Any violation will be held for legal responsibility. If you need to understand For more product introduction of cooling fan manufacturers, please click Product Center